Flash the Firmware

Click the "Flash the image" button in the device setup dialog.

When prompted, select the correct serial port for your ESP32 device. This is usually something like:

• Windows: COM3, COM4, etc.
• macOS/Linux: /dev/ttyUSB0, /dev/cu.usbserial, etc.

The flashing progress will be shown in the terminal. This process takes about 1-2 minutes.

After flashing is complete:

1. Exit bootloader mode on your device (disconnect and reconnect, or press reset)
2. Restart the device
3. The device will appear on your dashboard within a few seconds once it connects to WiFi